Restoring the A-10D Mitchell Wing

By

Scott McCarthy

Episode VI

Cable assembly.jpg (66439 bytes) Side view Battery and Elec System Plate.jpg (65152 bytes) Rear View Battery and Elec System Plate.jpg (79135 bytes) Front View Batt and Elec System Plate fitted to frame tubes.jpg (65556 bytes)
Rear View Batt Pwr Reg and starter solenoid on plate.jpg (65219 bytes) Pod in place with spreader bar holding wing attachment points at proper distance.jpg (74914 bytes) Mod 1 instrument panel mockup with cardboard cut-out instruments.jpg (60828 bytes) Battery plate on main frame inside pilots pod.jpg (67274 bytes)
Cardboard mockup of bent mushroom instrument panel.jpg (50354 bytes) Mushroom instrument panel outline transferred to aluminum plate.jpg (64569 bytes) Double sided foam tape applied to aluminum wing surface.jpg (68139 bytes) Mylar film pressed to the double sided tape.jpg (69336 bytes)
Mylar film with aluminized Mylar tape on the edges.jpg (67634 bytes) Mylar film with aluminized Mylar tape on edges.jpg (61093 bytes) Fiberglass repair of slot in wingtip shroud.jpg (73198 bytes)

Episode VI

Episode I   Episode II   Episode III   Episode IV   Episode V   Episode VII   Episode VIII   Episode IX

Back to Home Page